|
Return to Programming Home
Go to Step: 1 2 3
SENSOR PROGRAMMING - STEP 3
DEFINITION
Optional
programming features are available to adjust the sensor and display performance. Review the information below
for your
application.
|
Lockout |
|
A lockout feature is available to prevent changes to the
programming of the sensor. To activate, press the "Mode"
and Arrow Down" keys simultaneously. The letters
"LOC" appear blinking on the display indicating the sensor
programming features are now locked preventing any unwanted changes.
To unlock the programming features, repeat the above procedure. |
 |
|
Zero Reset |
|
This feature
is a manual calibration to reset your beginning value to zero. Press
the "Mode" key and hold for 3 seconds to reset the sensor. |
 |
|
Peak Value and Bottom Value |
|
To periodically check the high value of the system, press
the "Arrow Up" key one time. "PE" momentarily
appears on the display followed by the high value of the system
blinking. This feature automatically stops after 3 seconds. To
check the low value of the system, repeat this procedure by pressing the
"Arrow Down" key and "bo" will appear on the display. |
 |
SCREEN SAVER OPTION
Press the mode key three times to
activate this feature. To activate change the factory display
"OFF" to "ON" by using the "Arrow Up" or
"Arrow Down" keys. If activated, the display will
automatically turn off after 10 seconds saving 20mA of current
consumption. |
|
Go to Step: 1 2 3
|